PREVIEW - TESTED. DOCUMENTATION IN PROGRESS
The Delay Development Board has been designed to allow people to experiment with the Princeton Technologies PT2395 Enhanced Digital Echo IC. The delays produced by this chip are quite long, suitable for various forms of echo. As it stands it is not appropriate for use in chorus units or flangers, though it may be possible to achive this by dropping address lines. Other areas such as the feedback network also need improvement over what has been suggested on the application notes for this device, thus this board, to give an easy starting point for such experiments.
A little on how it works:
The schematic of the core of the Delay Development Board.
(Click here for high-res version)
The board is made up of several distinct blocks, some of which are not connected in any way.
The delay circuit is based on the application note for the PT2395, and I recommend you seek out the appropriate file. The desired file is called "PT2395.pdf" and is 519k in size. Note that there are a number of errors in this app, note. It is even contradictory in places. There are several other versions of the app. note/data sheet, but all are cut-down versions, and are more or less useless.
The component overlay. Connections can be determined from the circuit diagram and the text below.
This is one of those PCBs than can be assembled in a number of different ways to suit the builder's needs.
On the first run of boards, a track is missing. It runs between pin 4 of the NE570 and AGND (0 volts).
Note that some chips a mounted in the opposite direction to others on this board. Large arrows on the overlay make this clear.
There is a development area to the right end of the board, allowing a 74HC4046 and associated components to be fitted, including two 4024 divider chips. The theory is that voltage control of the delay can be achieved using the 74HC4046, and frequency dependent delays achieved using the phase-locked-loop. At this point this area has not been developed, and is up the the individual experimentor to use or ignore as s/he sees fit.
Connections to and from the PCB:
There are some capacitors marked as high precision in the app. note, and on the circuit diagram above. I suggest using 5% mylar capacitors or better (styrene, poly prop, poly carb, 1%, 2%, etc.) in these positions. Match them if you have a capacitance meter.
Before you start assembly, check the board for etching faults. Look for any shorts between tracks, or open circuits due to over etching. Take this opportunity to sand the edges of the board if needed, removing any splinters or rough edges.
When you are happy with the printed circuit board, construction can proceed as normal, starting with the resistors first, followed by the IC socket if used, then moving onto the taller components.
Take particular care with the orientation of the polarized components such as electrolytics, diodes, transistors and ICs.
When inserting ICs into sockets, take care not to accidentally bend any of the pins under the chip. Also, make sure the notch on the chip is aligned with the notch marked on the PCB overlay.
This is a guide only. Parts needed will vary with individual constructor's needs.
The delay chip can be purchased from Small Bear Electronics.
If anyone is interested in buying these boards, please check the PCBs for Sale page to see if I have any in stock.
Article, art & design copyright 2001 by Ken Stone